Toro Reelmaster 5210 Service Manual page 269

5. Check that roller brush has light contact with rear roll-
er (Fig. 47). If contact is incorrect, brush operation will
be adversely affected. Also make sure that brush shaft
is parallel with rear roller.
6. Lubricate grease fittings on brush housings until
grease purges past inboard seals. Wipe excess grease
from seals and fittings.
Reelmaster 5010 Series
2
1. Driven pulley
2. Drive pulley
2
1. Rear roller brush
2. Rear roller
Page 7 - - 39
1
Figure 45
3. Straight edge
Figure 46
1
3
Figure 47
3. Light contact
Cutting Units (Rev. C)
3