Rear Lift Arms - Toro Reelmaster 5210 Service Manual

Rear Lift Arms

13
16
17
27
11
28
27
RIGHT
FRONT
1. Spacer (2 used)
2. #2 lift arm
3. #3 lift arm
4. Washer (2 used per chain hoop)
5. Spring catch
6. Flange head screw (2 used)
7. Cap screw (2 used)
8. Flat washer (2 used)
9. Pivot pin (2 used)
10. Washer head screw (1 used per pin)
11. Pivot yoke (2 used)
Removal (Fig. 21)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove cutting unit from rear lift arm to be removed.
3. Remove one retaining ring (item 32) and thrust
washer (item 31) from the cylinder pin (item 30) that se-
cures the lift cylinder rod end to lift arm. Pull cylinder pin
from the lift cylinder and lift arm. Locate and retrieve sec-
ond thrust washer.
4. Pivot lift cylinder rod end away from lift arm.
Chassis (Rev C)
13
3 26
15
21
20
4
18
22
12. Lynch pin (2 used)
13. Thrust washer (2 used per yoke)
14. Spacer (2 used)
15. Grease fitting (2 used)
16. Snapper pin (1 used per yoke)
17. Cap (1 used per yoke)
18. Chain hoop (2 used)
19. Lock nut (2 used)
20. Cap screw (2 used per chain hoop)
21. Flange nut (2 used per chain hoop)
22. Chain (2 used)
12
7
8
14
19
29
15
29
9
10
Figure 21
Be careful when removing tension from the tor-
sion spring on the rear lift arms. The spring is un-
der heavy load and may cause personal injury.
5. Remove tension from torsion spring on rear of lift arm
pivot pin.
A. Insert nut driver or small piece of pipe onto the
end of the torsion spring that is secured on the rear of
the lift arm pivot pin.
Page 6 - - 24
5
23
1
25
2
31
30
32
31
23. RH torsion spring
24. LH torsion spring
25. Washer (2 used)
26. Flange bushing (2 used per arm)
27. Bushing (2 used per yoke)
28. Grease fitting (1 used per yoke)
29. Flange bushing (2 used per arm)
30. Cylinder pin (2 used)
31. Thrust washer (2 used per pin)
32. Retaining ring (2 used per pin)
CAUTION
Reelmaster 5010 Series
6
24
29
32
12
13
26