Toro Reelmaster 5210 Service Manual page 27

CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene- -glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
3. Drain coolant from radiator.
A. Slowly remove radiator cap from the radiator.
B. Place drain pan below the radiator draincock lo-
cated on the bottom of the radiator. Make sure that
drain pan is large enough to hold cooling system con-
tents (see Specifications in this Chapter).
C. Loosen draincock and allow coolant to drain from
radiator.
4. Remove screen from machine.
5. Disconnect radiator hoses (upper and lower) from
the radiator.
6. Loosen hose clamp and remove overflow hose from
radiator fill opening.
7. Remove two (2) flange head screws and flange nuts
that secure coolant reservoir and brackets to fan
shroud. Carefully position reservoir and brackets away
from the fan shroud.
8. Remove five (5) flange head screws and flange nuts
that secure air intake screen (item 37) to machine. Re-
move screen and foam seal (item 42). Locate and re-
trieve five (5) spacers (item 43).
9. Remove flange head screws and flange nuts that se-
cure fan shroud and radiator to radiator frame. Position
fan shroud away from the radiator.
10.Carefully pull radiator assembly from the machine.
Plug radiator and hose openings to prevent contamina-
tion.
11. Inspect all foam seals placed between radiator, fan
shroud and radiator frame. Replace damaged foam
seals.
Installation (Fig. 7)
1. Remove plugs placed in radiator and hose openings
during the removal procedure.
2. Carefully position radiator assembly to the radiator
support. Position fan shroud to the radiator.
Reelmaster 5010 Series
3. Secure fan shroud and radiator to radiator frame with
removed flange head screws and flange nuts. Make
sure that at least .250" (6.4 mm) clearance exists at all
points between shroud opening and fan.
4. Position coolant reservoir and brackets to the fan
shroud. Secure reservoir to fan shroud and radiator
frame with two (2) flange head screws and flange nuts.
5. Place spacers (item 43) into holes in foam seal (item
42). Position foam seal and air intake screen (item 37)
to radiator frame. Secure screen to machine with five (5)
flange head screws and flange nuts.
6. Connect upper and lower radiator hoses to radiator
and secure with clamps.
7. Connect overflow hose to radiator fill opening and
secure with hose clamp.
8. Make sure radiator draincock is closed (threaded out
fully). Fill radiator with coolant.
9. Lower hood. Install screen to rear of machine.
1
2
6
1. Radiator (RM 5610)
2. Fan shroud
3. Radiator frame
Page 3 - - 13
REELMASTER 5610
6
5
3
5
6
Figure 8
4. Flange head screw
5. Flange head screw
6. Flange nut
Kubota Diesel Engine
4
5