Lift Control Manifold Service - Toro Reelmaster 5210 Service Manual

Lift Control Manifold Service

25 ft- -lb
(33 N- -m)
48 to 60 in- -lb
(5.4 to 6.7 N- -m)
20 ft- -lb
(27 N- -m)
20 ft- -lb
(27 N- -m)
RIGHT
FRONT
1. Lift control manifold
2. Check valve (4 used)
3. Solenoid valve (SV3)
4. Solenoid coil
5. Solenoid coil spacer
6. Nut
NOTE: The ports on the lift control manifold are marked
for easy identification of components. Example: P4 is
the gear pump P4 connection port and SV2 is the loca-
tion for solenoid valve SV2. (See Hydraulic Schematics
to identify the function of the hydraulic lines and car-
tridge valves at each port location).
Hydraulic System (Rev. C)
48 to 60 in- -lb
(5.4 to 6.7 N- -m)
7
6
6
5
4
3
2
1
Figure 77
7. Solenoid valve (SV2)
8. Solenoid coil
9. Nut
10. Solenoid relief valve (SVRV)
11. Solenoid valve (SV1)
Page 4 - - 90
9
10
8
13
14
15
16
12. Relief valve (R7)
13. O- -ring
14. Pilot piston (4 used)
15. O- -ring
16. Hex plug (4 used)
25 ft- -lb
(33 N- -m)
6
48 to 60 in- -lb
(5.4 to 6.7 N- -m)
5
4
11
20 ft- -lb
(27 N- -m)
12
75 ft- -lb
(101 N- -m)
Reelmaster 5010 Series