Toro Reelmaster 5210 Service Manual page 211

5. Remove platform shroud from machine to allow ac-
cess to steering column fasteners (Fig. 3).
A. Remove cover plate from platform.
B. Remove fasteners that secure shroud to ma-
chine.
C. Remove shroud from machine.
D. Locate and retrieve two (2) rubber bushings and
spacers.
6. Slide rubber bellows up steering column to allow ac-
cess to fasteners that secure steering column to ma-
chine.
7. Support steering control valve to prevent it from fal-
ling during steering column removal.
8. Loosen and remove four (4) socket head screws
(item 6) that secure steering control valve to steering
column.
9. Loosen and remove four (4) flange head screws
(item 15) and flange nuts (item 7) that secure steering
column to machine.
10.Slide steering column assembly from steering con-
trol valve and machine.
11. Disassemble steering column assembly as needed
using Figure 4 as a guide.
Installation (Fig. 2)
1. Apply antiseize lubricant to input shaft of steering
control valve.
2. Slide steering column onto steering control valve.
Secure steering column in place with four (4) flange
head screws (item 15) and flange nuts (item 7).
3. Secure steering control valve to steering column with
four (4) socket head screws (item 6).
4. Slide rubber bellows to bottom of steering column.
5. Place rubber bushings and spacers into holes of
shroud. Position shroud in place and secure with re-
moved fasteners.
6. Slide foam collar onto steering column.
7. Thoroughly clean tapered surfaces of steering wheel
and steering column.
8. Apply antiseize lubricant to splines of steering col-
umn taking care to keep antiseize lubricant from column
taper. Slide steering wheel onto steering column.
Reelmaster 5010 Series
9. Secure steering wheel to steering column with flat
washer and lock nut. Torque hex nut from 20 to 26 ft- -lb
(28 to 35 N- -m).
10.Install steering wheel cover to steering wheel.
3
4
1. Washer (2 used)
2. Screw (2 used)
3. Washer head screw
4. Platform shroud
1
2
3
1. Steering column
2. Pin
3. Universal joint
4. Pin
5. Lock washer (2 used)
6. Cylinder
Page 6 - - 7
1
2
5
3
6
7
8
Figure 3
5. Lock nut
6. Cover plate
7. Bushing (2 used)
8. Spacer (2 used)
4
5
6
7
8
9
12
10
11
Figure 4
7. Bolt (2 used)
8. Pin
9. Pedal block
10. Pedal cover
11. Pedal
12. Spring
Chassis (Rev. C)