Toro Reelmaster 5210 Service Manual page 31

7. Remove plugs installed in hoses during disassem-
bly. Connect hoses to the engine:
A. Connect fuel supply and fuel return hoses to en-
gine fittings (Fig. 11). Secure with hose clamps.
B. Connect upper and lower radiator hoses to the
engine. Secure with hose clamps.
8. Connect throttle cable to injector pump (Fig. 10):
A. Route throttle cable to injector pump on engine.
B. Install the throttle cable end into the swivel in
speed control lever. Secure cable end with cap
screw.
C. Position cable under cable clamp.
D. Adjust throttle control (see Adjust Throttle Con-
trol in the Adjustments section of this chapter).
Reelmaster 5010 Series
9. Install air cleaner (see Air Cleaner Installation in this
section).
10.Install exhaust system to machine (see Exhaust
System Installation in this section).
11. Add coolant to radiator.
12.Check engine oil level and adjust if needed.
13.Connect positive (+) and then negative (--) battery
cables to the battery.
14.Bleed fuel system.
15.Close hood.
Page 3 - - 17 Kubota Diesel Engine