Toro Reelmaster 5210 Service Manual page 213

Removal (Fig. 5)
1. Park the machine on a level surface, lower the cut-
ting units and stop the engine. Remove the key from the
ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen, but do not remove, lock nut (item 17) from
wheel motor shaft.
4. Remove front wheel assembly (see Wheel Removal
in this section). Make sure to support machine with jack
stands.
5. Make sure parking brake is disengaged.
NOTE: Clevis pin that secures brake cable to brake ac-
tuator lever is secured with cotter pin (shown in Fig. 5)
or extension spring (shown in Figs. 6 and 7).
6. Remove cotter pin or spring from clevis pin that se-
cures brake cable to brake actuator lever. Remove cle-
vis pin and position brake cable away from brake
actuator lever.
7. Remove brake drum.
IMPORTANT: DO NOT hit wheel hub, puller or wheel
motor with a hammer during wheel hub removal or
installation. Hammering may cause damage to the
wheel motor.
8. Make sure that lock nut on wheel motor shaft is
loose. Use appropriate puller to loosen wheel hub from
wheel motor shaft.
9. Remove lock nut and wheel hub from motor shaft.
Locate and retrieve woodruff key.
NOTE: If desired, the complete brake assembly can be
removed from the machine for disassembly (see step
12).
10.Remove upper and lower shoe springs from brake
shoes.
11. Remove shoe hold down cups and hold down
springs. Remove brake shoes and hold down pins from
backing plate.
12.If necessary, remove backing plate from machine by
loosening and removing four (4) cap screws and lock
nuts.
Installation (Fig. 5)
1. Remove rust and debris from all parts with a wire
brush prior to installation. Clean all parts. Inspect brake
shoe contact surfaces of the brake drum for excessive
wear. Replace any worn or damaged parts.
Reelmaster 5010 Series
11
10
9
RIGHT
FRONT
405 to 495 ft- -lb
(550 to 671 N- -m)
1. Brake drum
2. Lock nut
3. Wheel hub
4. Cap screw (4 used)
5. Brake assembly
6. Cap screw (4 used)
2
3
4
5
6
RIGHT
FRONT
1. Brake assembly
2. Clevis pin
3. Brake spring bracket
4. Flange nut
Page 6 - - 9
STANDARD 2WD MACHINE WITH
EATON WHEEL MOTORS SHOWN
7
6
4
8
5
2
Figure 6
7. Brake adapter
8. Extension spring
9. Square key
10. Wheel motor (Eaton)
11. Lock nut (4 used)
1
8
7
Figure 7
5. Jam nut
6. Cap screw
7. Extension spring
8. Wheel motor (Parker)
Chassis (Rev. C)
3
1