Toro Reelmaster 5210 Service Manual page 209

Removal (Fig. 1)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen lug nuts.
CAUTION
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists
and jacks. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock or
block wheels. Use jack stands or other ap-
propriate load holding devices to support the
raised machine. If the machine is not properly
supported, the machine may move or fall,
which may result in personal injury.
4. Using a jack, raise machine so wheel is off ground
(see Jacking Instructions in Chapter 1 -- Safety). Sup-
port machine with jack stands.
5. Remove lug nuts and then remove wheel from ma-
chine.
Reelmaster 5010 Series
Installation (Fig. 1)
1. Install wheel and secure with five (5) lug nuts.
2. Lower machine to ground.
3. Torque lug nuts evenly in a crossing pattern from 70
to 90 ft- -lb (95 to 122 N- -m).
Page 6 - - 5 Chassis (Rev. C)