Proxim ORiNOCO AP-700 User Manual page 197

Hide thumbs Also See for ORiNOCO AP-700:
Table of Contents

Advertisement

Command Line Interface (CLI)
Configuring the AP using CLI commands
[Device-Name]>set snmprpasswd <New Password> (SNMP read password)
[Device-Name]>set snmprwpasswd <New Password> (SNMP read/write)
[Device-Name]>set snmpv3authpasswd <New Password> (SNMPv3 authentication password)
[Device-Name]>set snmpv3privpasswd <New Password> (SNMPv3 privacy password)
[Device-Name]>reboot 0
CAUTION:
Proxim
strongly urges you to change the default passwords to restrict access to your network devices to
authorized personnel. If you lose or forget your password settings, you can always perform the
Factory
Defaults.
Set Network Names for the Wireless Interface
[Device-Name]>set wif 3 netname <Network Name (SSID) for wireless interface>
[Device-Name]>show wif
Figure A-13 Results of "show wif" CLI command for an AP
Enable 802.11d Support and Set the Country Code
NOTE: On APs with model numbers ending in -WD, these commands are not available.
Perform the following command to enable 802.11d IEEE 802.11d support for additional regulatory domains.
[Device-Name]>set wif 3 dot11dstatus <enable/disable>
Perform the following command to set a country code:
[Device-Name]>set syscountrycode <country code>
Select a country code from the following table, derived from ISO 3166. Available countries will vary based on regulatory
domain. Refer to the ISO/IEC 3166-1 CountryCode drop-down menu on the Configure > Interfaces > Operational
Mode page; this menu contains a list of all the available countries in your regulatory domain.
NOTE: If you select a country code that is not supported in your regulatory domain, clients may attempt to connect to a
channel that is not supported by your AP.
Country
Algeria
Albania
Argentina
Code
Country
DZ
Honduras
AL
Hong Kong
AR
Hungary
Code
Country
HN
Panama
HK
Papua New Guinea
HU
Peru
AP-700 User Guide
Soft Reset to
Code
PA
PG
PE
196

Advertisement

Table of Contents
loading

Table of Contents