Proxim ORiNOCO AP-700 User Manual page 217

Command Line Interface (CLI)
Parameter Tables
DNS Client for RADIUS Name Resolution
Name
DNS Client
DNS Client status
Primary DNS Server IP
Address
Secondary DNS Server
IP Address
Default Domain Name
DHCP Server Parameters
Name
DHCP Server
DHCP Server Status*
Gateway IP Address
Primary DNS IP Address IpAddress
Secondary DNS IP
Address
Number of IP Pool Table
Entries
* The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
DHCP Server table for IP pools
Name
DHCP Server IP Address
Pool Table
Table Index
Start IP Address*
†
End IP Address*
†
Width
Default Lease Time
(optional)
Maximum Lease Time
(optional)
Comment (optional)
Status (optional)
* IP addresses must be from within the same subnet as the AP.
† Set End IP Address or Width, but not both.
Type
Group N/A
Integer enable
disable (default)
IpAddress User Defined
IpAddress User Defined
Integer32 User Defined (up to 254
characters)
Type
Group N/A
Integer enable (1) (default)
disable (2)
delete (3)
IpAddress User Defined
User Defined
IpAddress User Defined
Integer32 N/A
Type
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined
Integer32 3600 - 86400 sec
(default)
Integer32 3600 - 86400 sec
(default)
DisplayString User Defined
Integer enable (1)
disable (2)
delete (3)
Value Access
R
RW
RW
RW
RW
Value Access
R
RW
RW
RW
RW
R
Value Access
R
N/A
RW
RW
RW
RW
RW
RW
RW
AP-700 User Guide
CLI Parameter
dns
dnsstatus
dnspridnsipaddr
dnssecdnsipaddr
dnsdomainname
CLI Parameter
dhcp
dhcpstatus
dhcpgw
dhcppridnsipaddr
dhcpsecdnsipaddr
dhcpippooltblent
CLI Parameter
dhcpippooltbl
index
startipaddr
endipaddr
width
defleasetm
maxleasetm
cmt
status
216