Proxim ORiNOCO AP-700 User Manual page 208

Command Line Interface (CLI)
Configuring the AP using CLI commands
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Figure A-16 Result of "showradiustbl" CLI Command
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning
parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl 3 mode <1 for background scanning, 2 for continuous scanning>
cycletime <cycletime from 1–1440 minutes> status <enable/disable>
NOTE: Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is
shutdown. First, resume service on the wireless interface.
Set Hardware Configuration Reset Parameters
The Hardware Configuration Reset commands allows you to enable or disable the hardware reset functionality and to
change the password to be used for configuration reset during boot up.
To disable hardware configuration reset, enter:
[Device-Name]>set hwconfigresetstatus disable
To enable hardware configuration reset, enter:
[Device-Name]>set hwconfigresetstatus enable
To define the Configuration Reset Password to be used for configuration reset during boot up, enter the following
command
[Device-Name]>set configresetpasswd <password>
It is important to safely store the
NOTE: It is important to safely store the configuration reset password. If a user forgets the configuration reset password,
the user will be unable to reset the AP to factory default configuration if the AP becomes inaccessible and the
hardware configuration reset functionality is disable.
Set VLAN/SSID Parameters
Enable VLAN Management
[Device-Name]>set vlanstatus enable
[Device-Name]>set vlanmgmtid <1–4094>
[Device-Name]>show wifssidtbl (to review your settings)
[Device-Name]>reboot 0
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 0
: 0
: 5
AP-700 User Guide
207