Proxim ORiNOCO AP-700 User Manual page 25

Installation and Initialization
Hardware Installation
Figure 2-8 Opening the Antenna Compartment
2. There are two antenna connectors in the AP-700, labeled 1 and 2 Connect the antenna cable to connector 1 (the
connector closer to the LED panel in the compartment).
Figure 2-9 Antenna Connectors
3. If installing a second external antenna (not recommended), connect the antenna cable to connector 2.
4. Close the external antenna access compartment.
5. If desired, manually select which antenna(s) to use through the Command Line Interface.
Adjusting Tx Output Power
NOTE: When the system is set to transmit at the maximum power, professional installers must ensure that the maximum
EIRP limit is not exceeded. To achieve this, they may have to add attenuation between the device and the
antenna when a high gain antenna is used.
Use the following formula in combination with the table of EIRP limits in US, Canada, and EU countries to calculate
system transmit power (based on EIRP limits) of these countries:
Tx Power (dBm) = EIRP Limit (dBm) + FL (dB) – G (dB)
where:
Tx Power = Output power measured at the antenna input
EIRP Limit = EIRP limits specified below
AP-700 User Guide
25