Alarms; Groups - Proxim ORiNOCO AP-700 User Manual

Advanced Configuration

Alarms

Alarms
The Alarms tab has the following sub-tabs:
•

Groups

• Alarm Host Table
• Syslog
• Rogue Scan
Groups
Alarm groups can be enabled or disabled via the Web interface. Place a check mark in the box provided to enable a
specific group. Remove the check mark from the box to disable the alarms. Alarm severity levels are as follows:
• Critical alarms will often result in severe disruption in network activity or an automatic reboot of the AP.
• Major alarms are usually activated due to a breach in the security of the system. Clients cannot be authenticated
because an attempt at unauthorized access into the AP has been detected.
• Informational alarms provide the network administrator with some general information about the activities the AP is
performing.
Configuration Trap Group
oriTrapDNSIPNotConfigured
oriTrapRADIUSAuthenticationNotConfigured
oriTrapRADIUSAccountingNotConfigured
oriTrapDuplicateIPAddressEncountered
oriTrapDHCPRelayServerTableNotConfigured
oriTrapVLANIDInvalidConfiguration
oriTrapAutoConfigFailure
oriTrapBatchExecFailure
oriTrapBatchFileExecStart
oriTrapBatchFileExecEnd
Security Trap Group
oriTrapInvalidEncryptionKey
Trap Name
Trap Name
Description
DNS IP address not configured
RADIUS Authentication not configured
RADIUS Accounting not configured
Another network device with the same IP address
exists
The DHCP relay agent server table is empty or
not configured
A VLAN ID configuration is invalid
Auto configuration failed
The CLI Batch execution fails for the following
reasons:
• Illegal Command is parsed in the CLI Batch
file
• Execution error is encountered while
executing CLI Batch file
• Bigger file size than 100 Kbytes
The CLI Batch execution begins after file is
uploaded
The execution of CLI Batch file ends.
Description
Invalid encryption key has been detected.
AP-700 User Guide
Severity Level
Major
Major
Major
Major
Major
Major
Minor
Minor
Minor
Minor
Severity Level
Critical
94