Alarms Parameters - Proxim ORiNOCO AP-700 User Manual

Command Line Interface (CLI)
Parameter Tables
TCP/UDP Port Filtering Table
The following parameters are used to configure TCP/UDP Port filters.
Name
Port Filtering Table
Table Index
Port Type
Port Number
Protocol Name
Interface Bitmask
Status (optional)

Alarms Parameters

SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Type
Table N/A
N/A User Defined
(there are also 4
pre-defined indices, see
Port Number
more information)
Octet String tcp
udp
tcp/udp
Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service - 137, Index 2:
NetBios Datagram
Service - 138, Index 3:
NetBios Session Service
- 139, Index 4: SNMP
Service - 161)
DisplayString User Defined
(there are also 4
pre-defined protocols,
see
Integer32 0 or 2 = No interfaces
(disable)
1 or 3 = Ethernet
4 or 6 = Wireless
5 or 7 = All interfaces
(default is 7)
Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete
Type
Table N/A
Integer User Defined
IpAddress User Defined
Value Access
R
R
below for
RW
RW
RW
Port Number above)
RW
RW
Value Access
AP-700 User Guide
CLI Parameter
portflttbl
index
porttype
portnum
protoname
ifbitmask
status
CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
230