Command Line Interface (CLI)
Parameter Tables
Name
Hardware Configuration
Reset Status
Configuration Reset
Password
Security Profile Table
The Security Profile Table allows you to configure security profiles. A maximum of 16 security profiles are supported.
Each security profile can contain one or more enabled security modes (Non-secure station, WEP station, 802.1x station,
WPA station, WPA-PSK station, 802.11i, 802.11i-PSK). The WEP/PSK parameters are separately configurable for each
security mode. See the command examples in
Name
Security Profile Table
Table Index
Security Mode
Authentication Mode
Cipher
Encryption Key 0
Encryption Key 1
Encryption Key 2
Encryption Key 3
Encryption Transmit Key Integer
Encryption Key Length
PSK Passphrase
Encryption Key Format
If WEP security mode is configured, then the appropriate key size must be configured. The AP supports 63-, 128-, and
152-bit encryption keys. Encryption keys may be configured using either hexadecimal or ASCII values, as described in
the following table.
Key Length
64-bit
Type
Integer
DisplayString
Type
Table
Integer
Integer
Integer
Integer
Integer
Integer
Integer
Integer
Integer
Integer
Hexadecimal
10 characters (0 - F)
Value
enable (1)
disable (2)
User Defined
Set Security Profile
Parameters.
Value
N/A
1 - 16
nonsecure
wep
802.1x
wpa
wpa-psk
802.11i
802.11i-psk
none
802.1x
psk
none
wep
tkip
aes
See
Encryption Key
Format
See
Encryption Key
Format
See
Encryption Key
Format
See
Encryption Key
Format
0 - 3
1 (64 bits)
2 (128 bits)
3 (152 bits)
8 - 64 characters
ASCII
5 alphanumeric characters
AP-700 User Guide
Access
CLI Parameter
R
hwconfigresetstatus
RW
configresetpasswd
Access
CLI Parameter
R
secprofiletbl
RW
index
RW
secmode
R
authmode
R
ciphersuite
W
encryptkey0
W
encryptkey1
W
encryptkey2
W
encryptkey3
RW
encryptkeytx
RW
encryptkeylength
W
passphrase
236