Step 3 - Run Throttle Wizards - Seastar Solutions Optimus 360 Installation Manual

SECOND y-VALUE
Figure B-9. The engine response configuration wizards are found on the Setup tab.
© 2014 SeaStar Solutions
b.3.6
Step 3 – run throttle wizards
The engine response wizards will use the values acquired in STEP 2
to develop a relationship between throttle and RPM that the joystick will
use to improve its control of the vessel. Perform with boat safely
secured, or in an open area.
forward throttle wizard:
1. Press take command on the joystick. Ensure boost mode is off.
2. Click run port engine forward throttle wizard (see figure B-9).
The joystick's A LED will flash to indicate the port wizard is running.
3. Push and hold the joystick all the way forward. The wizard will
increase throttle from maximum idle throttle to maximum joystick
throttle (recorded in STEP 2) in increments, returning to zero
throttle before each increment.
a) If necessary, rotate the joystick to correct the boat's heading.
To abort the wizard release the joystick.
b) When the wizard finishes the LED will stop flashing. This takes
about one minute.
4. Click read to import the wizard values into Datalink.
5. Examine the second Y-value (see figure B-9) in the table. If it is
more than 100 RPM higher than the engine's in-gear idle RPM,
go back to STEP 2 and decrease FWD: Port Max Throttle at Idle
by 0.5%. Click write if you make a change.
Optimus 360 Installation Supplement, Rev. B
fINAL y- VALUE
b-9