Can2 Harness Connections - Seastar Solutions Optimus 360 Installation Manual

warnInG
faILure to Secure harneSS
may reSuLt In harneSS
wear, cauSInG LoSS of
SteerInG controL, property
damaGe, perSonaL Injury
and/or death.
PCM
FEMALE
TERMINATOR
CM10052
Figure 3-2. Generic CAN2 wiring diagram.
© 2014 SeaStar Solutions

3.5 CAN2 Harness Connections

The Optimus 360 system uses the same CAN2 network, cables and
structure as the basic Optimus EPS system. The Optimus 360 system
adds a joystick and control head (if applicable) to the CAN2 network.
Figure 3-2 shows a sample CAN2 network diagram. The exact
connections will vary depending on the engine manufacturer; consult
the OEM-specific sections of this manual for detailed network diagrams.
Refer also to Book 50 for CAN2 wiring, harness selection, and
installation best practices.
All tees must be secured using both screw holes, and the cable drops
at each tee must be appropriately secured and strain-relieved to prevent
any pull on the tees. See figure 3-3 for proper tee installation. Any
unused tees must either be capped or removed.
MALE
TERMINATOR
CM10051
NETWORK TEES CM10060 OR
SIX-PORT HUB CM20064
JOYSTICK
DEVICENET
HARNESS*
NETWORK TEES CM10060 OR
SIX-PORT HUB CM20064
Optimus 360 Installation Supplement, Rev. B
COLOR
CANtrak
4'
HARNESS
CM21504
* See Book 50 Optimus EPS Installation Manual
3-5