Seastar Solutions Optimus 360 Installation Manual page 42

SEASTAR
GATEWAY
HARNESS
9-PIN CONNECTOR
(NORMALLY LOCATED
3 TO 4 INCHES BELOW
THE CONTROL HEAD
HOUSING)
Figure 7-5. Status LED connector
identification and connection.
cautIon
7-4
8. Install a new cable tie to secure the harnesses to the chassis
and re-install the cover. (Refer to figure 7-4.)
NEW CABLE TIE
SEASTAR
GATEWAY
HARNESS
DASH
LPS HARNESS
CONNECTOR
Figure 7-4. Cable tie and cover installation.
9. Repeat steps 5–8 for the other side.
10. Re-install the control head in the dash. Take care not to pinch
or damage any harnesses. Re-install the binnacle cover. This is
a reversal of the removal procedure shown in step 2 and 3.
11. From behind the dash, find the 9-pin connection from the control
head, disconnect it, and plug the connectors to the portion of
the SeaStar gateway harness labeled 'LED' (Refer to figure 7-5).
all harness runs should be sufficiently bundled and strain relieved to
avoid accidental damage.
© 2014 SeaStar Solutions
COVER
Optimus 360 Installation Supplement, Rev. B
LPS HARNESS
CONNECTOR
SCREW x 3