Seastar Solutions Optimus 360 Installation Manual page 10

prior to every use
warnInG
during use
warnInG
after use
warnInG
1-2
Perform a system inspection as outlined below. Refer to Section 9.1
in the Optimus EPS Installation Manual (Book 50) for further details.
1. Check steering fluid level in all steering pumps.
2. Verify immediate steering response when turning steering wheel(s).
3. Inspect all steering hoses, fittings, mechanical cables, and
electrical harnesses for wear, kinks, or leaks.
4. Check for binding, loose, worn or leaking steering or shift/throttle
control components.
5. Verify proper shift and throttle response for all control levers.
6. Take control with the joystick and verify that steering, shift and
throttle respond to joystick movement.
7. Verify that no alarms or warnings are shown on the CANtrak display.
do not operate boat If any component IS not In proper
workInG condItIon.
1. WEAR A COAST GUARD-APPROVED PERSONAL FLOTATION
DEVICE (PFD).
2. ATTACH ENGINE SHUT-OFF CORD (LANYARD) TO YOUR PFD.
3. Never allow anyone who is not familiar with the operation of the
steering system to operate the boat at any time.
4. If boat is equipped with multiple helms, ensure that only one is
used at a time.
5. Know and adhere to all applicable federal, state, and municipal laws
and regulations that govern boating in your area.
do not operate boat If any component IS not In proper
workInG condItIon.
Rinse off the SmartCylinders thoroughly, using only fresh, clean water.
DO NOT rinse the PCM, pumps, actuators, or any other component of
the Optimus system. DO NOT use acetone, or cleaners containing
ammonia, acids, or any other corrosive ingredients, on any Optimus
component. Use only a damp cloth, or a mild detergent if necessary.
faILure to compLy wIth any warnInG, notIce or cautIon
may Lead to LoSS of SteerInG controL reSuLtInG In a
coLLISIon and/or ejectIon from the boat LeadInG to
property damaGe, perSonaL Injury and/or death.
© 2014 SeaStar Solutions Optimus 360 Installation Supplement, Rev. B