Yamaha Est Gateway Setup - Seastar Solutions Optimus 360 Installation Manual

© 2014 SeaStar Solutions

7.4 Yamaha EST Gateway Setup

Before configuring the EST gateway you should have already conducted
the initial system setup described in section 4.
If you have more than one control station you will need to configure
each gateway separately, as they need to be calibrated to their
adjacent remote control. The calibration wizard records the output
values from the remote control's lever position sensors (LPS) at
various lever positions.
The gateway calibration is performed easily with the CANtrak display.
If you prefer to use Datalink, see Appendix B.6 for instructions.
procedure
1. The gateway calibration must be performed with the engines
keyed on, but not running. Check the RPM reading on the color
CANtrak and the Yamaha display. Both should read 0 RPM at all
engines. If the RPM displays as '---' on the CANtrak, check your
speed source connections.
2. At the main station CANtrak, navigate to dealer menu > Initial
Setup > eSt Gateway to bring up the EST Gateway Setup
screen. If you have two gateways, and have correctly set the
number of gateways in section 4, then you will also see a 2nd
station gateway on your screen.
Figure 7-10.
3. Select calibrate main eSt Gateway and press >. This will put
the main station gateway into calibration mode.
Optimus 360 Installation Supplement, Rev. B
7-9