Can1 Harness Connections - Seastar Solutions Optimus 360 Installation Manual

CAN2 PORT
(SEE SECTION 3.5)
HARNESSES MUST
BE STRAIN RELIEVED
TO JOYSTICK
MOUNTING STUD
USING CABLE TIES
PROVIDED
CANtrak
Figure 3-1 CAN1 harness connections.
3-4

3.4 CAN1 Harness Connections

Refer to the Optimus EPS Installation Manual (Book 50) for CAN1
harness selection and connections.
In addition to this, the Optimus 360 system requires a 6-pin CAN1
harness connection between the steering helm and the joystick.
Refer to book 50 for proper harness selection
and strain relieving.
JOYSTICK
CAN1 HARNESS
TO HELM
HARNESS MUST BE
STRAIN RELIEVED TO HELM
HOUSING TAB USING
CABLE TIES PROVIDED
CM21504
HARNESS
© 2014 SeaStar Solutions
TO CAN2
NETWORK
NODE
HARNESS MUST BE STRAIN RELIEVED TO
PCM STRAIN-RELIEF PLATE.
Optimus 360 Installation Supplement, Rev. B
HARNESS TIE POINT X 4
ELECTRONIC
HELM
CAN1 HARNESS TO
PCM P1 PORT