Seastar Solutions Optimus 360 Installation Manual page 48

7-10
Figure 7-11.
4. The status indication will guide you through the calibration steps.
Move both control levers to the position indicated in the status
field. You will be directed in turn through the following:
a. Forward WOT – move the levers to the forward throttle stops
b. Forward detent – engage forward gear with levers in idle position
c. Neutral – put both levers in neutral
d. Reverse detent – engage reverse gear with levers in idle position
e. Reverse WOT – move levers to the reverse throttle stops
5. After the final calibration step the wizard will exit automatically.
6. Repeat the calibration wizard from the second station, if applicable.
© 2014 SeaStar Solutions Optimus 360 Installation Supplement, Rev. B