Step 3 - Run Throttle Wizards - Seastar Solutions Optimus 360 Installation Manual

notIce
© 2014 SeaStar Solutions
9.2.3 Step 3 – run throttle wizards
The throttle wizards will use the values acquired in STEP 2 to
develop a relationship between throttle and RPM that the joystick
will use to improve its control of the vessel. Perform this step with
the boat safely secured, or in an open area.
If you abort any of the wizards before they finish you must run them again.
1. Navigate to dealer menu > Initial Setup > joystick > run throttle
wizards.
Figure 9-8.
2. Press take command on the joystick. Ensure boost mode is off.
3. On the display, select run port fwd throttle wizard. The Throttle
Wizard status screen will be displayed, and the joystick's A LED
will flash to indicate that the port wizard is running.
Figure 9-9.
Optimus 360 Installation Supplement, Rev. B
9-7