Seastar Solutions Optimus 360 Installation Manual page 103

Figure B-24. Sample of final calibration values.
© 2014 SeaStar Solutions
4. The Calibration Step field will change to 'Forward Detent.' Move
the levers to the correct position, and when the Calibration Step
Status reads 'Ready,' click Save calibration point.
5. Continue in this manner through each lever position shown in the
Calibration Step field.
6. Once you've calibrated the last lever position, click read and the
LPS Calibration Values table will populate with the calibrated
values (see figure B-24). The LPS Calibration Status field will now
read 'Calibrated' to indicate that calibration is complete.
you are now ready to Sea trIaL the SteerInG SyStem.
refer to book 50. when the Sea trIaL IS compLete, proceed
to the joyStIck Setup In SectIon 9 of thIS manuaL.
Optimus 360 Installation Supplement, Rev. B
b-23