System Setup, Purge, And Calibration; Initial System Setup - Seastar Solutions Optimus 360 Installation Manual

notIce
The software update wizard uses
the system configuration you set
up here to automatically install
the correct software revisions for
your system. Don't update the
software until prompted in the
procedure.
© 2014 SeaStar Solutions
4.0 SySTEM SETUP, PUrgE,
AND CALIbrATION
Before you proceed you need to have all Optimus EPS and Optimus
360 components installed, harnesses connected, and ignition
sensing and power wiring completed. If you haven't already done so
you'll need to go to the section specific to your engine (section 5
through section 8) for network interconnection diagrams and some
engine-specific installation details. Do not do any engine-specific
setup or configuration at this time; you will need to perform the
initial setup first.

4.1 Initial System Setup

The system setup is performed easily with the color CANtrak display.
(If you prefer to use Datalink, see Appendix B.) It is designed to walk
you through the following tasks:
• Configure the system type
• Choose the number of helms and displays in your system
• Update system software
• Select device locations
You will need access to the CANtrak Dealer Menu for all setup
tasks. See Appendix D in the Optimus EPS Installation Manual
(Book 50) for instructions.
procedure:
1. On the display, navigate to dealer menu > Initial Setup >
System to access the System Setup menu.
Figure 4-1.
Optimus 360 Installation Supplement, Rev. B
4-1