Performance / Status Menu - Verilink DIDCSU 2912 Manual

DIDCSU E1 Version

Performance / Status Menu

Figure 4-13 Performance/Status Menu
-- -- DIDCSU 2912 PERFORMANCE/STATUS MENU -- DIDCSU 2912 PERFORMANCE/STATUS MENU --
-- -- DIDCSU 2912 PERFORMANCE/STATUS MENU -- DIDCSU 2912 PERFORMANCE/STATUS MENU --
LOS LOS
LOS LOS
LOF LOF LOF LOF
AIS Rx/Tx AIS Rx/Tx AIS Rx/Tx AIS Rx/Tx
RAI Rx/Tx RAI Rx/Tx RAI Rx/Tx RAI Rx/Tx
SLIP SLIP SLIP SLIP
CRC4 CRC4 CRC4 CRC4
BER BER BER BER
RMAS RMAS RMAS RMAS
P) display performance data P) display performance data P) display performance data P) display performance data
C) display counters C) display counters
C) display counters C) display counters
A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 >
A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 >
Table 4-10 Performance Menu
Acronym
LOS
LOF
AIS
RAI
SLIP
CRC-4
BER
RMAS
4-20
The Performance/Status Menu is used to monitor the functioning
and condition of the network ports. The parameters in this screen
count the various problems that occur in a given period of time.
Performance information is logged in 15-minute intervals over a
24-hour period.
To access the Performance/Status Menu from the Main Menu,
enter P.
PORT 1 PORT 1
PORT 1 PORT 1
NO NO
NO NO
NO NO NO NO
NO/NO NO/NO NO/NO NO/NO
NO/NO NO/NO NO/NO NO/NO
NO NO NO NO
NO NO NO NO
NO NO NO NO
NO NO NO NO
T) threshold Alarm T) threshold Alarm T) threshold Alarm T) threshold Alarm
X) exit this screen X) exit this screen
X) exit this screen X) exit this screen
Use the Performance/Status Menu to monitor the following
Loss-of-Signal: A major alarm indicating no receive pulses at all. May be caused
by disconnected or miswired network cable. Supercedes all other alarms. Ignore
other alarms and troubleshoot this condition first.
Loss-of-Frame: No frame synchronization.
Alarm Indication Signal: A pattern of unframed all-ones sent to indicate trouble
on a T1, reflects a condition known as Red Alarm.
Remote Alarm Indication: Yellow Alarm—a signal sent by a device in a Red Alarm
state.
Indicates unexpected variations in clock rate.
Cyclic Redundancy Check: Method for detecting bit-errors.
Bit Error Rate: the selected tolerable rate of errors.
Remote Multiframe Alignment Signal.
Verilink DIDCSU 2912 User Manual
PORT 2 PORT 2
PORT 2 PORT 2
NO NO
NO NO
NO NO NO NO
NO/NO NO/NO NO/NO NO/NO
NO/NO NO/NO NO/NO NO/NO
NO NO NO NO
NO NO NO NO
NO NO NO NO
NO NO NO NO
Description