Verilink DIDCSU 2912 Manual page 100

DIDCSU E1 Version
Figure 4-21 Circuit Build Configuration Menu
Circuit Manager -- [1,1] NCM 2000 Firmware 5.04 -- Circuit Manager -- [1,1] NCM 2000 Firmware 5.04 --
Circuit Manager -- [1,1] NCM 2000 Firmware 5.04 -- Circuit Manager -- [1,1] NCM 2000 Firmware 5.04 --
>>>>>> NO CIRCUIT FOUND IN DATABASE <<<<< >>>>>> NO CIRCUIT FOUND IN DATABASE <<<<<
>>>>>> NO CIRCUIT FOUND IN DATABASE <<<<< >>>>>> NO CIRCUIT FOUND IN DATABASE <<<<<
A) add circuit A) add circuit A) add circuit A) add circuit
D) delete circuit D) delete circuit D) delete circuit D) delete circuit
P) prev page P) prev page P) prev page P) prev page
N) next page N) next page N) next page N) next page
X) exit to craft main menu X) exit to craft main menu
X) exit to craft main menu X) exit to craft main menu
A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 >
A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 >
4-28
Each circuit must include a minimum of one network port (circuits
are not supported from data port to data port).
Figure 4-20 Circuit Example
Data 1
Data 2
A. Data to E1
B. E1 to E1
The port line code selection (for example, 56 kbit/s or 64 kbit/s
circuits) can limit a circuit's configuration.
NOTE: Network and data ports must be
into a circuit.
When you have named a circuit and identified its source and
destination ports, allocate its source and destination timeslots.
NOTE: You can cross-connect DIDCSU circuits across the AS2000
backplane to other DIDCSU modules. However, an NCM 2000
module is required. Refer to the NCM 2000 User Manual for
more information on this feature.
L) search circuit L) search circuit L) search circuit L) search circuit
E) edit circuit E) edit circuit E) edit circuit E) edit circuit
I) activate circuit I) activate circuit I) activate circuit I) activate circuit
R) deactivate circuit R) deactivate circuit R) deactivate circuit R) deactivate circuit
Verilink DIDCSU 2912 User Manual
A
Net 1
B
Net 2
In Service before being built