Configure Network Port - Verilink DIDCSU 2912 Manual

DIDCSU 2912 Quick Set-Up
Configure
Network Port
Figure 2-4 Configuration Menu
-- DIDCSU 2912 CONFIGURATION MENU -- -- DIDCSU 2912 CONFIGURATION MENU -- -- DIDCSU 2912 CONFIGURATION MENU -- -- DIDCSU 2912 CONFIGURATION MENU --
P) T1 port P) T1 port P) T1 port P) T1 port
X) exit this screen X) exit this screen X) exit this screen X) exit this screen
A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 > A [0.0.0.204] [1,2] DIDCSU 2912 >
2-4
8. Once the bus assignment has been made, reboot the DIDCSU
by reseating the front module in its slot.
9. Reconnect the Craft cable to the NCM L
DIDCSU 2912 has completed the reset a process of negotiation
for shelf master will occur. During this time the SYS LED on the
DIDCSU will be amber. Once the SYS LED becomes steady
green, the NCM has control of the DIDCSU—proceed to step 10.
10. From the NCM Craft interface Main Menu
the DIDCSU application module using option "S", Shelf/Slot.
Note that now the Main Menu shows brackets around the
letter A, indicating the DIDCSU is the currently selected
module.
11. From the Main Menu, select option "C" to start the
configuration task.
D) data port D) data port D) data port D) data port
12. From the Configuration Menu
access the T1 Port Configuration Menu
Verilink DIDCSU 2912 User Manual
port. When the
OCAL
(Figure 2-2), select
(Figure 2-4), select option "P" to
(Figure 2-5).