Table of Contents
Advertisement
DIDCSU 2912 Quick Set-Up
Select FASE Alarm
Category
Select E1 Framing
Type
Set Alarm Declare
Time to 2 Seconds
Disable Inband
Management
Select no DS0 for
Inband
Management
Timing Options
Figure 2-19 Timing Options
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
Current shelf timing source: Card 2, NET 1
Current shelf timing source: Card 2, NET 1
Current shelf timing source: Card 2, NET 1
Current shelf timing source: Card 2, NET 1
Source
Source
Source
Source
Slot Number
Slot Number
Slot Number
Slot Number
PRIMARY
PRIMARY
PRIMARY
PRIMARY
PC) 2
PC) 2
PC) 2
PC) 2
SECONDARY
SECONDARY
SECONDARY
SECONDARY
SC) 2
SC) 2
SC) 2
SC) 2
TERTIARY
TERTIARY
TERTIARY
TERTIARY
TC) 2
TC) 2
TC) 2
TC) 2
R) Receive clock from shelf:
R) Receive clock from shelf:
R) Receive clock from shelf:
R) Receive clock from shelf:
X) exit this screen
X) exit this screen
X) exit this screen
X) exit this screen
2-16
16. Type "S1", then "2" to select Major as the alarm category for
Frame Alignment Signal Errors on Net Port 1. Type "S2", then
"2" to set the same for Net Port 2.
17. Type "M1", then "2" to select Common Channel Signaling (CCS)
as the E1 framing type on Net Port 1. Type "M2", then "2" to
set the same for Net Port 2.
18. Type "N1", then "2" to set the number of elapsed seconds
before declaring an alarm condition for Net Port 1. Type "N2",
then "2" to set the number of elapsed seconds before
declaring an alarm condition for Net Port 2.
19. Type "B1", then "N" to disable inband for Net Port 1. Type
"B2", then "N" to disable inband for Net Port 2.
20. "L1" and "L2" are not used because no inband timeslot (DS0) is
reserved for management in this example.
21. From the Configuration Menu, select "T" for the Timing
Options submenu.
Synchronization
Synchronization
Synchronization
Synchronization
PS) NET 1
PS) NET 1
PS) NET 1
PS) NET 1
SS) NET 2
SS) NET 2
SS) NET 2
SS) NET 2
TS) INTERNAL
TS) INTERNAL
TS) INTERNAL
TS) INTERNAL
YES
YES
YES
YES
22. Type "R", then "Y", then refresh the screen by pressing E
Observe that some of the menu items change depending on
whether the "Receive clock from shelf" option is YES, or NO.
Use the PC, PS, PA, SC, SS, SA, TC, TS and TA commands to
configure the DIDCSU as shown in
23. Use "X" to exit to the E1 Port Configuration Menu. Then use
"X" again to exit to the Configuration Menu.
Verilink DIDCSU 2912 User Manual
(PRIMARY)
(PRIMARY)
(PRIMARY)
(PRIMARY)
Auto Restore
Auto Restore
Auto Restore
Auto Restore
PA) YES
PA) YES
PA) YES
PA) YES
SA) YES
SA) YES
SA) YES
SA) YES
TA) YES
TA) YES
TA) YES
TA) YES
Figure
.
NTER
2-19.
Advertisement
Table of Contents
