Timing Options - Verilink DIDCSU 2912 Manual

DIDCSU 2912 Quick Set-Up
Allow Network
Originated Loops
Set Alarm Declare
Time to 2 Seconds
Disable Facilities
Data Link
Select no DS0 for
Inband
Management
Disable Inband
Management

Timing Options

Figure 2-6 Timing Options
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)-- -- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)-- -- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
Current shelf timing source: Card 2, NET 1 Current shelf timing source: Card 2, NET 1
Current shelf timing source: Card 2, NET 1 Current shelf timing source: Card 2, NET 1
Source Source Source Source Slot Number Slot Number Slot Number Slot Number
PRIMARY PRIMARY PRIMARY PRIMARY PC) 2 PC) 2 PC) 2 PC) 2
SECONDARY SECONDARY SECONDARY SECONDARY SC) 2 SC) 2 SC) 2 SC) 2
TERTIARY TERTIARY TERTIARY TERTIARY TC) 2 TC) 2 TC) 2 TC) 2
R) Receive clock from shelf: R) Receive clock from shelf: R) Receive clock from shelf: R) Receive clock from shelf:
X) exit this screen X) exit this screen
X) exit this screen X) exit this screen
2-6
18. Type "NL1", then "Y" to allow network initiated loops on Net
Port 1. Type "NL2", then "Y" to allow network initiated loops
on Net Port 2.
19. Type "A1", then "2" to set the number of elapsed seconds
before declaring an alarm condition for Net Port 1. Type "A2",
then "2" to set the number of elapsed seconds before
declaring an alarm condition for Net Port 2.
20. We do not need FDL connectivity to the far-end. Type "DL1",
then "N" to disable FDL for Net Port 1. Type "DL2", then "N" to
disable FDL for Net Port 2.
21. "S1" and "S2" are not used because no inband timeslot (DS0) is
reserved for management in this example.
22. Type "E1", then "2" to disable inband for both ports.
23. From the Configuration Menu, select "T" for the Timing
Options submenu.
Synchronization Synchronization Synchronization Synchronization
PS) NET 1 PS) NET 1 PS) NET 1 PS) NET 1
SS) NET 2 SS) NET 2 SS) NET 2 SS) NET 2
TS) INTERNAL TS) INTERNAL TS) INTERNAL TS) INTERNAL
YES YES YES YES
24. Type "R", then "Y", and press E
Observe that some of the menu items change depending on
whether the Receive clock from shelf option is YES, or NO.
Use the PC, PS, PA, SC, SS, SA, TC, TS and TA commands to
configure the DIDCSU as shown in
25. Use "X" to exit to the T1 Port Configuration Menu. Then use
"X" " " " again to exit to the Configuration Menu.
Verilink DIDCSU 2912 User Manual
(PRIMARY) (PRIMARY)
(PRIMARY) (PRIMARY)
Auto Restore Auto Restore Auto Restore Auto Restore
PA) YES PA) YES PA) YES PA) YES
SA) YES SA) YES SA) YES SA) YES
TA) YES TA) YES TA) YES TA) YES
to refresh the screen.
NTER
Figure 2-6.