Format/Field Store - SATO E series Programming Manual

Section 4: Expanded Memory Commands
Command Structure
Command Function
Printer Input
Printer Output
Special Notes
Page 4-6

Format/Field Store

<ESC>YS,aa<ESC>/N,bb,cc{.......}
aa = Format number to be stored (01-99)
bb = Field number to be stored (01-99)
cc = Length of field to be stored (01-99)
{.....} = Command stream describing the field to be stored.
Example: <ESC>YS,01<ESC>/N,01,05
Placement: Immediately after <ESC>CC Memory Area Select command.
Default: None
To store a format field description in the memory card.
ESC>A
<ESC>CC1
<ESC>YS,02<ESC>/N,01,13<ESC>V0100<ESC>H0100<ESC>XB1
<ESC>/N,02,13<ESC>V0200<ESC>H0200<ESC>XB1
<ESC>Z
There is no printer output as a result of this command. See <ESC>YR
Format/Field Recall command.
1. This command requires the Expanded Memory option. See your SATO
representative for details.
2. Each job should be sent individually. If more than one job is sent in a
data stream, only the first one will be accepted and the remainder
ignored.
3. The following commands cannot be stored in a format:
<ESC>CS Print Speed
<ESC>NULL Cut Label
<ESC>/D Recall Field
<ESC>T Custom Characters
<ESC>@ Off Line
<ESC>BJ TrueType Fonts
<ESC>G Store Custom Graphics
<ESC>BT Variable Ratio Bar Codes
<ESC>0 Partial Edit
<ESC>C Repeat Label
<ESC>Q Print Quantity
<ESC>EX Expanded Label Storage
<ESC>& Store Form Overlay
<ESC>#E Print Darkness
<ESC>ID Store Job ID
<ESC>* Clear Memory & Buffer
<ESC>PI Store PCX Graphics
SATO Programming Reference