Configuration Commands - SATO E series Programming Manual

Appendix A: Command Code Quick Reference

CONFIGURATION COMMANDS

Instruction Description
AOa Auto Online. Allows the automatic online on power up setting to be
enabled or disabled.
CLa CR/LF Delete. Deletes the occurance of CR/LF characters in the data
stream.
LFa Online Feed. To enable or disable online label feed.
LHa Zero Slash. Allows printing zeroes with or without a slash.
I2abcde Serial Interface. Sets the operating parameters for the Serial RS232C
interface. Sets the default printer configuration in Flash ROM. See Serial
Interface Parameters command in the Configuration Commands of
Section 5: Programming Reference of this manual for details.
IGa Sensor Type. Selects the sensor type.
LD,a,b,c,d,e, Download Protocol Command Codes. Downloads a user defined set
f,g,i, j j of Alternate Protocol Command Codes. See Appendix E for details on
the proper usage of this command.
PCaa,bb Printer Setting. Sets the default printer configuration in Flash ROM.
PCF,a,.....z See Printer Setting command in the Configuration Commands of
Section 2: Command Codes of this manual for details.
PHa Print Type. Selects the thermal printing method.
PMa Print Mode. Selects desired backfeed operation.
Page A-14
a = 0 Printer powers up in Online mode
1 Printer powers up in Offline mode.
a = 0 Do not delete CR/LF.
1 Delete CR/LF
a = 0 Enables label feed when online.
1 Disables label feed when online.
a = 0 Prints zeroes without a slash.
1 Prints zeroes with a slash.
a = 0 Reflective (Eye-Mark) sensor.
1 Transmissive (See-Thru) sensor
2 Sensor not used
a = 0 Thermal transfer printing
1 Direct thermal printing
a = 0 No backfeed, continuous operation
1 Tear-Off
2 Cut, backfeed after print
Page
SATO Programming Reference
6-14
6-12
6-14
6-13
6-11
6-10
6-2
6-4
6-9
6-8