SATO E series Programming Manual page 128

Section 6: Configuration Commands
COMMAND FUNCTION
INPUT TO PRINTER
PRINTER OUTPUT
SPECIAL NOTES
Page 6-6
Placement: Separate data stream sent to printer
Default: None
To set the printer default configuration into EEPROM
<ESC>A
<ESC>PC26,0
<ESC>Z
There is no printer output as a result of this command. This command
example enables the buzzer.
1. All command setting values must be in ASCII format.
2. These settings are stored in EEPROM and will remain valid until
receipt of another <ESC>PC command.
3. All positions in this command must be separated by a comma. If the
parameter. To change multiple settings, the correct number of com-
mas must be placed in the command, i.e. to change the label gap
sensor to reflective (eye-mark), the command would be:
<ESC>PC, , , , , , , , ,0, , , , , , , , , , , , , , , , , .
4. If only one setting is to be changed, the "aa" parameter must be an
"F".
SATO Programming Reference