SATO E series Programming Manual page 155

Instruction Description
(data)
U Font type.. Specifies a 5W x 9L dot matrix font (including descenders).
Vbbbb Vertical Position. Specifies a field's vertical location down the length of
the label from the current base reference point. Units of measurement
are dots.
WBa Font type. Specifies the 18W x 30L dot matrix font (including
descenders).
WDHaaaaVbbbb Copy Image Area. To copy an image to another location of the label.
XccccYdddd
aaaa
bbbb
dddd
WKnn...n Job Name. Stores the job name.
nn..n
WLa Font type. Specifies the 28W x 52L dot matrix font (including
decenders).
XM Font type. Specifies the 24W x 24H dot matrix font (including
descenders).
XS Font type. Specifies the 17W x 17H dot matrix font (including
descenders).
XU Font type. Specifies the 5W x 9L dot matrix font (including
descenders).
XWa Font type. Specifies the 48W x 48L dot matrix font (including
descenders).
SATO Programming Reference
2 24 x 24 matrix
b = Specifies data stream format to follow
B Binary
H Hexadecimal
cc = Memory location to store the character. Valid locations
are 21 to 52 or "!" to "R" in hex values.
= Data to describe the character.
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is greater
than 3
= Horizontal position of the top left corner of image area
= Vertical position of the top left corner of image area
cccc = Horizontal length of image area
= Vertical length of image area
= Job name, up to 16 ASCII characters
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is greater
than 3
a = 0 Disables auto-smoothing of font
Appendix A: Command Code Quick Reference
Page
2-26
2-53
2-31
2-21
2-41
2-31
2-26
2-26
2-26
2-31
Page A-7