SATO E series Programming Manual page 121

Special Notes
SATO Programming Reference
1. Contact SATO Technical Support for specific usage information.
2. Parameters "c", "d", "ee", "f f" and "gg" are not used for Micro QR
Code.
3. Parameter "xx...x" is limited to 0001 to 0486 bytes for Model 1 and
Micro QR Code.
4. The data command should be used according to the input mode or
data type.
5. In Automatic Mode, the data for 80
interpreted as Kanji, not binary data.
6. In Manual Mode, The multiple data fields for numeric, alphanumeric,
Kanji and binary can be specified in a job. In this case, the data fields
for <ESC>2D30 and each data field must follow the data field. Also,
the maximum data size should be less than 7000 bytes and the maxi-
mum block number for the data field is 200.
7. If the parameters are not correctly specified, the symbol will not be
printed.
Section 5: Two-Dimensional Symbols
to 9F or E0
H H H
to FF will be
H
Page 5-13