Pitch Offset - SATO E series Programming Manual

COMMAND STRUCTURE
COMMAND FUNCTION
INPUT TO PRINTER
PRINTER OUTPUT
SPECIAL NOTES
SATO Programming Reference

Pitch Offset

<ESC>POabcc
a = 3 Continuous
b = + Positive Offset
- Negative Offset
cc = 00 to 99, Offset value in dots
Example: See above
Placement: Separate data stream sent to printer
Default: Default value set by <ESC>PG command
To set the pitch offset used for a job.
<ESC>A
<ESC>PO3+20
<ESC>Z
Blank label
1. When power is cycled, the value set by this command is lost and
replaced by the default value stored in the EEPROM.
2. To change the value stored in the EEPROM, use the <ESC>PC
Printer Setting command or use the Printer Setting Utility program
contained on the CDROM shipped with the printer.
Section 6: Configuration Commands
Page 6-7