Cisco Unity Installation Manual page 99

To program the phone system
This procedure provides general information about programming
a phone system; refer to the phone system documentation for
specific information.
a Assign extensions for the voice messaging ports.
b If the phone system supports hunt groups, program the
hunting order for the voice messaging extensions (port 1 to
port 2, and so on).
If the phone system does not support hunt groups, you can
simulate a hunt group by forwarding each voice messaging
extension to the next extension in the simulated hunt group
on busy.
c If the phone system supports hunt group access codes,
assign a hunt group access code for the voice messaging
extensions. This code is the number that subscribers dial
internally to connect to the Unity server.
d Program which trunks (if any) will route to the voice messag-
ing extensions.
e Program the phone system to handle calls when all voice
messaging ports are busy. Calls may be forwarded to an
operator, get a busy signal, or get a ringback tone until one
of the ports becomes available.
Next section
TURNKEY SYSTEM
All configurations
COMPONENT SYSTEM
All configurations
CHAPTER 4: Setting up the integration
"Testing the integration," on page 92
"Testing the integration," on page 92
91