Cisco Unity Installation Manual page 49

Phone system
You connect the phone system during the procedure "To set up
the Unity or ActiveFax server," on page 42. See "Hardware set-
tings" for your voice or fax board in Appendix A for information
about pinouts on boards in the Unity server. Refer to the follow-
ing list for connection information for an integration type or a
specific phone system:
Connect the voice messaging lines to the
Analog integrations
voice boards in the Unity server.
Serial integrations Connect the voice messaging lines to the
voice boards in the Unity server, and connect the serial cable to
the COM1 serial port on the Unity server. The Unity Integration
Guide provides information about connecting Fujitsu 9600,
Toshiba DK280/424, NEC NEAX 2400, Mitel, and Centrex
phone systems to the Unity server. (Adapters for connecting the
serial cable are provided.)
See the Norstar Voice Mail Interface Installation
Norstar VMI
Guide for connection instructions.
Nortel/Calista and Lucent/Calista See the Unity Integration
Guide for connection instructions.
VoiceBridge 2000 Connect the voice messaging lines to the
VoiceBridge 2000 feature-set boards in the Unity server.
To route fax messages directly to users' e-mail Inboxes, the
phone lines that will be used for faxes must be DID lines or ana-
log lines, and must send the fax ID of the recipient. In addition,
the lines must be connected directly to the fax boards, either on
the Unity server or on the ActiveFax server.
CAUTION: You cannot use a serial integration for fax lines.
Continued
41
CHAPTER 3: Installing a Unity system