Table of Contents
Advertisement
Hardware settings
Do the following procedure as you install voice boards.
To set the I/O address DIP switch
Use these settings as you install the AG-T1 voice boards accord-
ing to the Natural MicroSystems documentation.
Set the I/O address DIP switch on each board as shown
below.
Board
First board
Second board
Third board
Fourth board
Software settings
During Unity Setup, do the following procedure when the NMS
Configurator dialog box appears.
To enter AG-T1 settings during Unity Setup
a Select a country.
b Change the value of "ISA Interrupt" to "5."
c Click "Add board." The Configure Board dialog box appears.
d Type a name for the board in the "Board name" box (for
example, Board 1).
e In the Board Type list, click "AG T1."
f In the TAPI Lines list, click "24."
APPPENDIX A: Voice and fax boards
DIP switch settings
On
Off
1 2 3 4 5 6
On
Off
1 2 3 4 5 6
On
Off
1 2 3 4 5 6
On
Off
1 2 3 4 5 6
I/O address
82C0
A2A0
C2C0
E2C0
Continued
155
Advertisement
Table of Contents
