Cisco Unity Installation Manual page 86

Setting up fax ports
for ActiveFax
Continued
78
UNITY INSTALLATION GUIDE
g Type the maximum number of digits that ActiveFax uses to
identify the recipient. The value that you enter depends on
the automatic routing method and on your organization's
phone system. This value is the number of digits used in the
"Fax ID" box in subscriber accounts. ActiveFax determines
the recipient by comparing the right-most digits of the
inbound fax number to the right-most digits of the fax num-
ber stored in each subscriber's Exchange mailbox, until it
finds a match.
h Type the number of rings before the fax port answers a call.
i Select an automatic routing method for inbound faxes: DID,
DTMF (telco), DTMF (manual), DNIS, or VPS.
j Repeat steps b through i for each port for which you are
entering setup information.
k Click "OK." The FAX Monitor window reappears.
To start the LFdriver
If Unity is running, you must start the LFdriver so that faxes can
be sent and received.
In the FAX Monitor window, click "Start" on the LFdriver
menu. (Starting the driver may take a few minutes.)