Cisco Unity Installation Manual page 139

Software settings
During Unity Setup, the Dialogic D/SC Configuration dialog box
appears. Do the following procedure after you have done the pro-
cedure "To enter VoiceBridge 2000 settings during Unity Setup,"
on page 161.
To enter Dialogic settings during Unity Setup
a Change the value of "BLTInterrupt" to the appropriate value:
All turnkey systems, except Dell 2400
Dell 2400 turnkey system
Component system
ing the procedure "To find and reserve memory addresses
and an IRQ (ISA boards in a component system only)," on
page 35.
b Change the value of "BLTAddress" to the appropriate value:
Turnkey system
Component system
during the procedure "To find and reserve memory
addresses and an IRQ (ISA boards in a component system
only)," on page 35.
c Click "OK" to continue.
d Return to the procedure that you were doing when the Dia-
logic D/SC Configuration dialog box appeared.
APPPENDIX A: Voice and fax boards
Select "5."
Select the IRQ that you reserved dur-
Select "D0000."
Select the address that you reserved
Select "2."
131