Prerequisites Requirements Cisco recommends that you have a working knowledge of the Cisco UCS hardware and software. Components Used The information in this document is based on Cisco UCS. The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a default configuration.
Page 2
Conventions Refer to the Cisco Technical Tips Conventions for more information on document conventions. Main Task Create Service Profile for Autoconfig Policies Perform these steps: In the navigation pane, select the Servers tab. Right−click Service Profile Template and select Create Service Profile.
Page 3
Click Next. If needed, assign any Storage and Networking to this Service Profile. Click Next.
Page 4
If needed, assign Server Boot Order to this Service Profile. Click Next.
Page 5
In Server Assignment, choose the Host firmware and Managament firmware to be applied to the blades. Click Next.
Page 6
After you have created the Service Profile, the next task is to create the Autoconfig Policies to apply to this Service Profile. Perform these steps: Log in to Cisco UCS Manager. In the navigation pane, select the Equipment tab. Select the Policies tab in the work pane.
Page 7
Fill in the required fields within the Create Autoconfiguration Policy pop−up window. Make sure you tie this Autoconfiguration Policy to the Service Profile you have created. Click OK.