History - Texecom Premier 24 Installation Manual

System Overview

1. History

This section shows the key milestones in the product development history, helping to identify when particular features were
implemented.
!
To confirm the Panel Type and software version, press
software version will be displayed.
Version 1.8
•
Support for iD.
iD wiring supported via Premier 24iXD Expander.
•
Ability to print the log.
System log can be printed to serial printer
connected to Com port 1.
Version 2.0
•
Software changed for new issue 8 PCB.
Version 2.02
•
GSM UDL enabled.
Wintex up and downloading supported on
ComGSM.
Version 2.04
•
Triple EOL (anti mask) support.
Version 7 – Issue 2 Manual
•
EN50131 and DD6662 functionality.
Features required for EN50131 & DD6662 added
– eg keypad blanking.
•
Support for iProx proximity tag readers.
•
Support for 4XP 4 zone expander.
•
Support for Radio Plus.
Intelegent Receiver supported on Com port 2.
(This is the internal receiver).
•
Support for Premier OP8.
On board 8 channel output expander.
4
! followed by " on the keypad. The panel type and
Version 7.1
•
Disarm with Radio FOB only after entry.
Option to prevent unsetting by radio FOB until
entry timer started.
•
Anti mask works on keypads and expanders.
Version 7.5 – Issue 2 Manual with Addendum ADD030-3
•
PSU Monitor support.
PSU monitor option on 8XP Expander auxiliary
input.
Premier PSU Monitor.
Premier PSU200XP monitored power supply.
•
AC off logged.
Mains failure recorded in system log.
Version 7.8
•
Support for RadioPlus Network Receiver.
Version 8 – Issue 3 Manual
•
500 event Mandatory Log added.
•
Option for silent radio FOB PA.
•
Radio shock sensor supported.
Support for Intelligent Radio Shock Sensor added
in preparation for future introduction.
•
Additional EOL and TEOL circuits supported.
Alternative End-of-Line and Triple-End-of-Line
resistor values supported for compatibility with
other manufacturers products.
•
Access users logged.
Door strike events recorded in the system log.
Premier 24 Installation Manual
INS248