4 Replacement Procedures
4.13 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable is not caught between the display
assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-17, 4-
18.
1. Turn the computer so the back is facing you and remove two M2.5x6 black flat head
screws.
2. Restore the normal computer placement and open the display panel.
.
M2 5x6 black flat head screw
Figure 4-17 Removing the screws from the back of the computer
3. Disconnect the CCD cable from CN4 on the system board.
4. Disconnect the MIC cable from CN16 on the system board.
5. Remove six M2.5x3.5 white flat head screws securing the LCD module to the bottom
cover.
6. Remove the wireless antenna cables, CCD cable, LCD/FL cable and MIC from the
bottom cover.
7. Remove the display module.
4-36
Satellite/Satellite Pro/A500/A505/A507/dynabook
4.13 Display Assembly
Maintenance Manual