Reset Modes - Extron electronics TouchLink TLP 710MV User Manual

Reset Modes

The TLP 710MV and TLP 710TV have four reset modes that correspond to four of the
five reset modes for the IP Link controllers. The modes are initiated by pressing the Reset
button.
To access the Reset button on the TLP 710MV, remove the bezel. See page 5 to locate
the
back panel. See page 10 to locate the
Mode Activation
1 Hold down the Reset button while
applying power to the TLP 710.
NOTE: After a mode 1 reset is
performed, update the TLP 710
firmware to the latest version.
Do not operate the firmware
version that results from this
mode reset. To use the factory
default firmware, reload that
version. See page 21 for details
about uploading firmware.
3 Hold down the Reset button for
approximately 3 seconds until the
Reset LED blinks once. Then release
and press Reset momentarily (less
than 1 second) within 1 second.
4 Hold down the Reset button for
approximately 6 seconds until the
Reset LED blinks twice (at 3 seconds
and 6 seconds). Then release and
press Reset momentarily (less than
1 second) within 1 second.
NOTE: Nothing happens if the
momentary press does not
occur within 1 second.
5 Hold down the Reset button for
approximately 9 seconds until the
Reset LED blinks three times (at 3,
6, and 9 seconds). Then release and
press Reset momentarily (less than
1 second) within 1 second.
NOTE: Nothing happens if the
momentary press does not
occur within 1 second.
Reset button on the TLP
TLP 710 MV and TLP 710TV Reset Mode Summary
Result
The TLP 710 reverts to the factory default
firmware. Event scripting does not start if the
TLP 710 is powered on in this mode. All user files
and settings (GUI, adjustments, IP settings) are
maintained.
NOTE: If you do not want to update firmware or
This mode turns events on or off.
NOTE: Nothing happens if the momentary
This mode:
•
Enables ARP capability.
•
Resets the IP address to the factory default
(192.168.254.254).
•
Resets the subnet to the factory default.
•
Resets the gateway address to the factory
default.
•
Turns DHCP off.
This mode performs a complete reset to factory
defaults (except the firmware). It does everything
that mode 4 does and, in addition:
•
Removes button and touchpanel
configurations.
•
Resets all IP options
•
Removes all scheduling options.
•
Removes and clears all files from the TLP 710.
710MV. The Reset button on the TLP 710TV is on the
Reset button on the
you performed a mode 1 reset by mistake,
cycle power to the TLP 710 to return to the
firmware version that was running before the
mode 1 reset.
press does not occur within 1 second.
TLP 710MV and TLP 710TV • Reset Modes
TLP 710TV.
Purpose and Notes
This mode reverts to the
factory default firmware
version if incompatibility
issues arise with
user-loaded firmware.
NOTE: User-defined
web pages may
not work correctly
with an earlier
version of the
firmware.
This mode is useful for
troubleshooting.
This mode enables
you to set IP address
information, using ARP
and the MAC address.
This mode is useful
to start over with
configuration and
uploading.
42