Table of Contents
Advertisement
The Sleep timer buttons determine how long the panel will be inactive before it enters
Sleep mode, when the screen goes dark to save power. The time can be changed from 0
to 50,000 seconds (in 10-second increments). The time that is currently selected is shown
above the buttons.
The screen may need a high level of backlighting for readability when ambient lighting is
high. With low ambient lighting, the backlighting should be low.
Auto Backlight provides a suitable amount of backlighting that is automatically calculated
from the amount of ambient light detected by the light detector.
When Auto Backlight is set to Off, the Backlight buttons allow the backlighting to be set
manually from 0 to 100 percent.
NOTE:
Wake on Motion activates the panel from Sleep mode when motion is detected near the
unit. Use the on-screen buttons to toggle the Auto Backlight or Wake on Motion options
between
Volume Screen
Figure 14.
Press the
Down
•
•
•
•
When Auto Backlight is set to
this does not affect the amount of backlighting until Auto Backlight is inactivated.
and
.
Off
On
Main
Down
Volume
Time
Down
Network
Video
Down
Down
Exit
Volume Screen
or
buttons to highlight one of the adjustable audio features. Use the
Down
Up
and
buttons to adjust the following settings.
Up
Master volume (between
0
the other sound volume settings. For example, if the master volume is set to
(approximately 80 percent of maximum), even when the Line In volume is set to
(maximum), it is equivalent to only 80 percent of maximum.
Click (between
and
; default
0
255
accompanies events such as a screen button being pressed.
Sounds (between
and
0
255
playback.
Line In (between
and
0
255
through the line in from an Extron MTP transmitter.
, the value of Backlight can be changed but
On
Master: 120
Up
Click: 120
Up
Sounds: 120
Up
Line In: 120
Up
and
; default
) sets the maximum volume for all
255
120
) sets the volume for audible feedback that
120
; default
) sets the volume of audio from any audio file
120
; default
) sets the volume of the audio signal received
120
TLP 710MV and TLP 710TV • Initial Calibration
200
255
15
Advertisement
Table of Contents
