Conversion Gear - Sony DCR-HC39E Service Manual

3-24.Conversion Gear

1. Removal procedure
1) Remove the belt 1 from the conversion gear.
2) Remove the conversion gear 2 from the conversion gear shaft.
2 Conversion gear
Do not remove the capstan motor assy.
1 Belt
Conversion
gear shaft
Apply Grease
Points to be noted
Apply grease when installing it.
Amount of grease:
a ball of grease of 1.0 mm
diameter
DV MECHANICAL ADJUSTMENT MANUAL VII
2.
1)
2)
3)
Apply grease
Conversion
gear shaft
— 35 —
Attachment procedure
Apply grease to the conversion gear shaft.
Amount of grease: a ball of grease of 1.0 mm diameter
Install the conversion gear 2 in the conversion gear shaft.
Hook the belt 1 on the conversion gear in a slant angle and
install it by rotating the conversion gear with fingertip.
BELT
Key Points in Re-assembling
Hook the belt 1 on the
conversion gear in a slant angle.
• The belt must not override on the capstan motor block assy.
• When installing the belt, the belt must not have any twisting,
dust, scar or grease must not be splashed on belt.
The belt must not be twisted.
The belt must not override on
the capstan motor block assy.