Timing Belt (L), Rc Gear Assembly; Loading Lever Assembly, Timing Bett (S ); Connecting Gear Assembly; Rk Gear Assembly - Sony CCD-F35 Service Manual

3-15. TIMING BELT (L) , RC GEAR ASSEMBLY,
1.
)
2)
3)
4)
5S)
Oy
oY
8)
9)
LOADING LEVER ASSEMBLY, TIMING
BELT (S), CONNECTING GEAR ASSEMBLY
Removal (See Fig. 3-16.)
Remove the DC motor (capstan motor) as described in
section 3-3.
Remove the pinch roller sub arm assembly as described in
section 3-14.
Set the [STOP] mode.
Remove the stopper washer @ , then remove the RC gear
assembly @ from the axle @ with the timing belt (L) @
attached.
Remove the timing belt (L) @ from the idler pulley
assembly @.
Remove the stopper washer @ and remove the loading lever
assembly @ while pushing the claw @ in the direction of the
arrow @.
Turn the stopper @ approx. 90° in the direction of the
arrow @.
Remove the connecting gear assembly @ from the axle @
with the timing belt (S) @ attached.
Remove the timing belt (S) @ from the idler pulley
assembly @.
© Timing Belt (L)
°}
@ Stopper Washer
@ Idler Pulley Assembly
@® RK Gear Assembly
1)
2)
3)
4)
9%)
Installation (See Fig. 3-16.)
Apply half a drop of oil to the axle @ (See Fig. F).
Hook one end of the timing belt (S) @ onto the connecting
gear assembly @ and the other end onto gear @ of the idler
pulley assembly @. (Refer to the figure.)
Mount the connecting gear assembly @ with the timing belt
(S) @ attached to the axle ®.
Tum the stopper @ in the direction of the arrow @ as far as
it will go.
Apply half a drop of oil to the axle @ (See Fig. A).
Fit the loading lever assembly @ to the axle ®, secure the
© part with the claw @ and place the pin ® into the groove
of the drive gear (right) assembly @.
Install the stopper washer @.
Place the timing belt (L) @ around the gears of the RC gear
assembly @ indicated in Fig. B, and its opposite side around
the gear @ of the idler pulley assembly @. (See Fig. E.)
Mount the RC gear assembly @ onto the axle @ with the
timing belt (L) @ attached, and engage it with the gear of
the RK gear assembly ®.
10) Install the stopper washer @.
11) Grease parts of the loading lever assembly @ indicated in
Fig. C.
12) Mount the pinch roller sub arm assembly as described in
section 3-14,
13) Mount the DC motor (capstan motor) as described in section
@ Timing Beit (S)
3.3.
oil co
© Stopper Washer
ie Axle]
| Connecting Gear
Assembly
© Loading Lever Assembly Fig. A Fig. D
Ol Tdler Pulley
Assembly .
® Connecting Gear a |e
RC Gear
Assembly oe
© Stopper
Fig. B
Fig.
Half a drop of oil
°