Table of Contents
Advertisement
4-5 Accommodating Various Kinds of Media
W 1180 mm
Description
The media width can be sensed automatically for opaque media, but not for transparent media. This means that the width
and mounted location of the media must be set manually. Incorrect settings may cause ink to be applied at locations where
no media is present. To quit making settings at the [SHEET POS.] menu item, use
front cover and press
Note that to keep the heads from drying out, the [SHEET POS.] menu item ends automatically after a certain interval, even
if you're still making settings there. The settings for the media width and start position made here are effective only when
[SHEET TYPE] is set to "CLEAR." Selecting "OPAQUE" disables the settings, although the setting values are saved in memory.
Choosing "CLEAR" again enables the values set previously.
When you're using transparent media, this unit cannot detect the trailing edge of the media automatically, so printing does
not stop when the media runs out. When you're using transparent media, then before you carry out printing, first check the
size of the printing data and the amount of remaining media.
Default Setting
[SHEET TYPE]: OPAQUE
[SHEET WIDTH]: 1371 mm (RS-540), 1625 mm (RS-640)
74
Chapter 4 Feature Reference
Press
to go back to the original screen.
.
U s e
heads.
Align this surface with
the edge of the media.
After positioning, close the front cov-
er.
Press
to enable the setting.
to select "CANCEL", then close the
t o m o v e t h e
Advertisement
Table of Contents
