Cutting Off the Media
Procedure
Close the front cover.
Make sure
FUNCTION
SHEET CUT
REMOVE
MEDIA CLAMPS
Press
.
The media is cut off.
You can make the setting in the software RIP for automatic media cutoff after printing has finished. For information on
how to make the setting, refer to the documentation for the software RIP you're using.
Cut-off Operations
○ Be sure to detach the media clamps. Performing cutoff with the media clamps remaining attached may
cause the operation to be interrupted due to detection of the media clamps.
○ If the media clamps are present on the machine when the setting to execute automatic cutoff of the me-
dia is made on the computer, the media clamps are detected and no cutoff operation is performed.
○ When you're performing cutoff, never use
has been pulled out to a location to the front of the platen, cutoff may not be performed smoothly.
lights up.
Press
.
Press
several times.
Press
.
The screen in the figure appears.
Media clamp
Remove the one on the left
as well.
Cutter groove
Printed portion
2-2 Loading and Cutting Off Media
Open the front cover and detach the
left and right media clamps.
Cutter groove
The media is fed to
the front.
The media is cut off here.
to pull the media back. Unless the end of the media
Chapter 2 Operation
37